Extra low rise electrohydraulic lift for cars with min. travel 96mm and double platform. Platforms connected by double torsion beam for perfect synchronicity and levelling. 

Double redundant hydraulic circuit with 4 pistons, 2 on each platform, with safety and shut-off valve on the hydraulic circuit for overload protection and hoses breaks. Self-lubricating axle bearings on each rotating pin, no maintenance required, High-sliding and self-lubricating polyethylene sliding pads. Lowering speed control with compensation valve. “Hold to run” 24V Control.

Electric Micro Switch with “foot guard” device and acoustic signal, to protect the last lowering travel. Suitable for both floor and recessed installation, even under difficult conditions in case of not available deep pits.


Electro-hydraulic Control Unit in metal structure (without plastic parts)
Capacity 3000 kg
Power Unit Kw 1,1 400V 3Ph 50Hz
Total weight 450kg
Lifting height max 1000 mm
Up-Down Travel speed 20/20sec
Equipped with 4 flap run- up ramps
Hoses covered with anti-blast sheath
Kit of 4 rubber pads h 20mm


Rubber pads h 40mm
Rubber pads h 60mm
Additional run-up ramps for racing / super sport vehicles
Kit for built-in central cover
Kit for recessed frame
Kit for built-in slides for horizontal standing ramps position
Hose extension
Hose carter
Additional crossbars for vehicles
Single-Phase motor